cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
gskumar
Contributor
Contributor
596 Views
Registered: ‎02-25-2013

Microblaze is not being clocked.

Hi,

We have a design with Microblaze processor targeted to Virtex-7 VC707 FPGA board. The design has our controller interfaced to Microblaze processor and Xilinx's Memory interface controller. This was perfectly working on the board. Recently we enabled the Interrupt interface on the Microblaze and as part of this we also included the interrupt controller block. We tried to excute the "hello world" program using this design, but we get the error "Cannot stop Microblaze. Microblaze is not being clocked". I have attached the snapshot of the error. Could you help us in addressing this issue?

rgds,

sunil

 

microblaze is not beeing clocked.PNG
0 Kudos
1 Reply
calebd
Moderator
Moderator
526 Views
Registered: ‎01-09-2019

Hello @gskumar 

Can you provide a screenshot of the Vivado block diagram?  It sounds like the error is related to the clocking/pins of your design.

Have you seen this person with a similar error? https://forums.xilinx.com/t5/Embedded-Processor-System-Design/Microblaze-is-not-being-clocked/td-p/562819

That might provide some insight to what could have caused your error, and may be worth trying their solution.

Thanks,

Caleb


------------------------------------------------------------------------------------------------

Don’t forget to reply, kudo, and accept as solution.

If starting with Versal take a look at our Versal Design Process Hub and our
Versal Blogs

------------------------------------------------------------------------------------------------
0 Kudos