cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
mrihani
Visitor
Visitor
7,181 Views
Registered: ‎02-10-2016

Partial Reconfiguration with Vivado 2015.4.1 for ZYNQ

Jump to solution

Hello,

Is there a way to apply partial reconfiguration using Vivado from GUI as I have already done using PlanAhead?

or only I should use tcl commands ?

0 Kudos
1 Solution

Accepted Solutions
mrihani
Visitor
Visitor
13,403 Views
Registered: ‎02-10-2016

Thank you
I tried the Xilinx User Guide and it worked, I was using PlanAhead before that and it was only GUI, now I am used to the Tcl commands

View solution in original post

0 Kudos
3 Replies
smarell
Community Manager
Community Manager
7,064 Views
Registered: ‎07-23-2012
Here is an example-http://www.wiki.xilinx.com/XAPP1231+-+Partial+Reconfiguration+of+a+Hardware+Accelerator+with+Vivado+Design+Suite
-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.
0 Kudos
mrihani
Visitor
Visitor
7,022 Views
Registered: ‎02-10-2016

Thanks for the reply

I see the example, I didn't know how to add mulitiple netlists for the reconfigurable block and how to create mulitiple partial and static bit streams. It is not clear for me, I have already done that before in PlanAhead it was mush easier.

0 Kudos
mrihani
Visitor
Visitor
13,404 Views
Registered: ‎02-10-2016

Thank you
I tried the Xilinx User Guide and it worked, I was using PlanAhead before that and it was only GUI, now I am used to the Tcl commands

View solution in original post

0 Kudos