cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
cor
Visitor
Visitor
577 Views
Registered: ‎07-01-2018

Zynq ultrascale+ clocking

Hi

I'm new to the Zynq Ultrascale family. And I'm a bit confused about how to clock the PL stuff.

The PS can generate 4 clocks. Is this mend to clock all kind of PL stuff? Or is this mainly mend for the axi busses?

 

I need for instance a low jitter 200MHz clock for MIPI interfaces. Can I use the PS clocking system for that? Or is that not the way to go and should I use an external oscillator connected to the FPGA and use a PLL or MMCM to generate this clock?

If so, what are the clock inputs to use? I do not see dedicated clock inputs.

 

And how to generate a general purpose 150MHz PL clock without jitter requirements. Using the PS output clocks for this is fine?

 

 

0 Kudos
0 Replies