cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
JohnsonHu
Observer
Observer
300 Views
Registered: ‎08-13-2020

coefficient files for traffic_gen are not up to date

Jump to solution

Hi,

It's a convenient to have traffic_gen to initial the IP's via coefficient files via axi_lite interface.

I need to modify the coefficient files (atg_addr.coe, atg_data.coe, etc)  and re-run the simulation to verify the developing modules. 

I tried to "close the simulation", "close the project", even "re-enter the Vivado" to let the simulator re-load the new coefficient files; however, the updated coe files seems not be updated, from the inspection of m_axi_lite* signals.  

Please help.

Johnson

0 Kudos
1 Solution

Accepted Solutions
florentw
Moderator
Moderator
163 Views
Registered: ‎11-09-2015

Hi @JohnsonHu 

If you are using a Block Design (BD), you will probably need to reset and re-generate the BD output products.

If you are not using a BD you will probably need to regenerate the IP output products


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos
1 Reply
florentw
Moderator
Moderator
164 Views
Registered: ‎11-09-2015

Hi @JohnsonHu 

If you are using a Block Design (BD), you will probably need to reset and re-generate the BD output products.

If you are not using a BD you will probably need to regenerate the IP output products


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos