11-26-2014 01:16 AM
After varying the stack size, the code ran wihtout any rpoblems..
but, everytime i rerun the code the s2mm buffer value is changing though the input values are not changed.
why is this happening??
11-14-2017 04:25 AM
I am using vivado 2013.3 and xilinx sdk of same version.
I am also trying to run fft+zynq example on ZC702 board. I modified tcl script for zc702 as tutorial says.
It run well enough if i keep my fft point length =2048. after that it fails. and got stuck. i increased satck and heap size. and debug it but for 4096 I found interrupt never gets generated.
if any solution please do share with me.
11-14-2017 04:30 AM
I stuck with same problem.
stack size upto 16mb
I am able to run fft upto 2048. But if I increase my FFT LENGTH then software hungs and I have to reset whole system.
I am unable to understand why interrupt is not generating for >2048.
11-24-2017 08:21 AM
May be this can help since I had the same trouble (..2048 = ok then hang for 4096 points - no irq raised).
I had to fix my generated project at 'ctrl/axi_dma_0' :
2048 points, the tx length is 4*2048=8192 bytes.
4096 points, the tx length is 4*4096=16384 bytes.
8192 points, the tx length is 4*8192=32768bytes.
The value of WBLR was 14 bits so 2^14-1=16383 bytes that is not enough for our 4*4096=16384 bytes.
Increasing the value to 15 bits and it worked with 4096 points but not with 8192 points.
Increasing the value to 16 bits and 8192 worked.
Hope this may help.