02-07-2016 11:54 PM
I have 2 questions.
1) I have a zynq zc 7020 processor. I need to utilize the UART0 of PS and connect it with my WIFI module CC3200. CC3200 is a 4 wired UART. I want to know whether this can be done on vivado? What is the procedure to do it. Should i connect the UART signals in the Zynq PS to the CC3200 by writing a HSDL code?
2) Can I generate a constraints file for the PS subsection by enabling the PS UART? Or is it only if I connect the AXI GPIO or some submodules that i can generate the constraints file?
02-08-2016 03:48 AM
02-08-2016 07:58 PM
Thank you for the replly. I will need only Tx, Rx, RTS and CTS signals of UART 0. Do I need to use AXI UART 16550 ip core to bring these signals to the outside world so that they can be connected to the CC3200 module on my PCB? Please confirm.
02-08-2016 08:49 PM
02-08-2016 10:20 PM
Okay. Is the AXI UART 16550 for the 3rd UART which I may create in the PL? To bring PL uart signals externally?
12-06-2018 03:24 AM
I have a problem. I have a zybo board zynq7000, I want use UART PS, what Pins use zybo for send and receive data? i need a code for send and receive a message.
please help me. Thanks.