UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
463 Views
Registered: ‎01-27-2016

Sleep / standby mode at Zynq7000

Hello,

 

for power-saving reasons I'd like to add routines for using sleep/standby mode in a zynq.

The procedure is discussed in the Technical Reference Manual(UG585) around pages 676 ff, and I already have seen some posts about it in the past.

But what I haven't found yet is a code example in C or assembler to enter and exit sleep mode.

 

Is there even a  library or application note regarding this?

 

I'm running FreeRtos on a Zynq7000 and would like to add a function to the idle-loop, where the sleep mode is entered and exited by tick interrupt.

 

Any suggestions on this?

 

Regards, Hannes

0 Kudos