cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
taimur123
Observer
Observer
3,095 Views
Registered: ‎09-21-2016

Vivado Simulator Background color.

Jump to solution

111.pngHi All, 

Is it possible to change the background color of simulations in Vivado Simulator from Black to white? I looked up, but couldn't find the authentic answer. 

The background color from black to white.

 

Regards

Taimur

111.png
1 Solution

Accepted Solutions
hj
Moderator
Moderator
3,849 Views
Registered: ‎06-05-2013

Hi,

Check the following snapshot and click on the small waveform option button. And change the colors.

 

wave_1.JPG

-------------------------------------------------------------------------------------
For more information please refer to configuration resources https://forums.xilinx.com/t5/FPGA-Configuration/Configuration-Resources/m-p/753763/highlight/true#M5891
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

3 Replies
hj
Moderator
Moderator
3,084 Views
Registered: ‎06-05-2013

Yes. If I am looking at the same color setting Check the below snapshot.

 

Click on the corner setting GUI button and set the color preference.

 

Thanks

Harshit

 

white_back.JPG

-------------------------------------------------------------------------------------
For more information please refer to configuration resources https://forums.xilinx.com/t5/FPGA-Configuration/Configuration-Resources/m-p/753763/highlight/true#M5891
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
taimur123
Observer
Observer
3,069 Views
Registered: ‎09-21-2016

Thanks for reply @hj , but in my simulator there is no corner setting button. I'm using Vivao 2015.4.

0 Kudos
hj
Moderator
Moderator
3,850 Views
Registered: ‎06-05-2013

Hi,

Check the following snapshot and click on the small waveform option button. And change the colors.

 

wave_1.JPG

-------------------------------------------------------------------------------------
For more information please refer to configuration resources https://forums.xilinx.com/t5/FPGA-Configuration/Configuration-Resources/m-p/753763/highlight/true#M5891
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post