cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
4,235 Views
Registered: ‎05-19-2008

GTP PLL lock issue

Hi,

 

I use in my design the GTP Core generated by the Wizard. I use the four tiles using only the PLL0s, each tile is the same. I also used two user clocks (one for TX (lane speed: 0.64Gbps) and one for RX(1.28Gbps)). So I have 6 PLLs. My GTP design is completely symmetrical.

 

Only one PLL (PLL0) of the MGT_USRCLK block is locked, the other (PLL1) is locked for a short time, then is unlocked for another short time before being re-locked for a short time and so on....

 

For the tile PLLs, only the WEST PLLs is locked and the EAST PLLs have the same behavior than the MGT_USRCLK PLL1.

 

Does somebody have an idea why the behavior of the PLL is like that???? Maybe a solution ???

 

Thanks,

Regards,

Nicolas.

---------------------------------------------
Device : XC6SLX150T-2fgg676
SW : ISE 13.1 updated
---------------------------------------------
Tags (3)
0 Kudos
3 Replies
Highlighted
Teacher
Teacher
4,233 Views
Registered: ‎09-09-2010

Re: GTP PLL lock issue

Which device?
What software version?

And you would be more likely to get an answer posting in the "Connectivity" forum:
http://forums.xilinx.com/t5/Connectivity/bd-p/CONN

------------------------------------------
"If it don't work in simulation, it won't work on the board."
0 Kudos
Highlighted
Visitor
Visitor
4,231 Views
Registered: ‎05-19-2008

Re: GTP PLL lock issue

Sorry, I forgot them.... I will put them in my signature...

 

Device : XC6SLX150T-2fgg676

SW : ISE 13.1 updated

 

I don't think it's a connectivity issue but rather a S6 PLL issue, that why I post here.... :smileywink: but ok, I' m going to post it on the Connectivity Forum....

Nicolas.

---------------------------------------------
Device : XC6SLX150T-2fgg676
SW : ISE 13.1 updated
---------------------------------------------
0 Kudos
Anonymous
Not applicable
4,120 Views

Re: GTP PLL lock issue

 
Did you ever get this one figured out?
 
I am seeing a very similar issue on the Same device and SW version.
 
Al... 
Tags (1)
0 Kudos