Unable to add zynq ultrascale IP in Vivado IP Integrator

[mnanoop2014]

Hi,

I have been following the Xilinx embedded design tutorial (UG1209).
When I press the add IP (+) button, and type in Zynq, the only IP visible in the drop down is Zynq ultrascale + VCU.

I am unable to figure out from where Zync Ultrascale + MPSoC IP can be added.

Edit: More info: Vivado 2018.2, Zynq Ultrascale+ MPSoC ZCU102-Evaluation board, node-locked licence that came with the board purchase.

TIA

Anoop

[tenzinc]

Mnanoop2014,

Which Zynq ultrascale+ device have you selected in Vivado? What version of Vivado? What vivado license package?

Regards,

T

[mnanoop2014]

Info updated :)

[anunesgu · Accepted solution]

Hi @mnanoop2014,

Can you double check in your project settings if the board ZCU102 is correctly selected (as in the image below)?

I suspect it might be set to a VCU instead.

Thanks,

[mnanoop2014]

Silly me! I had not explicitly "clicked" on the board that appeared when I selected "Zynq Ultrascale+ ZCU102" from the drop down in "select board" screen, since that was the only board that popped up and there was neither a selection check box nor multiple entries.