05-14-2020 07:12 AM
Hi Xilinx Team,
The Kintex Ultrascale plus "kintexu_grp1.ibs" IBIS model with the buffer model of HSTL logic (HP_HSTL_I_DCI_M_OUT40) is not correct.
The device output waveform is not meeting the specified noise margins (VOH, VOL & VREF) as per the datasheet.
Also, the waveform is having lot of jitter and eye crossing is not at the Vref level.
Here is the waveform snapshot attached for reference.
1) HSTL logic [Buffer Model : HP_HSTL_I_DCI_M_OUT40 (Driver Output)]
2) HSTL logic [Buffer Model : HP_HSTL_I_DCI_M_OUT40 (with load)]
Please share your comments at the earliest.
05-14-2020 04:54 PM
Can you please confirm your data rate?
It looks like your UI is ~350ps (~2800Mbps). If that is true, you are running beyond the maximum speed for the HSTL IO Standard. It is limited to 1600Mbps.
Can you please tell me if you are probing at the pin or the die? Can you please share a capture of your setup?
05-16-2020 09:44 AM
05-22-2020 12:27 PM
I created an RLD3 example design targeting the xcku115_flvf1942 and used it to generate a custom IBIS model.
05-26-2020 08:02 AM
Thank you for the response.
But in the IBIS model for the RLD RAM, I can see it is mentioned that it supports HSTL logic.
Can I use
Kindly provide your feedback.
05-26-2020 09:13 AM
You should only use the IO Standard set by the IP. This should be SSTL12. Can you please tell me where you are seeing HSTL associated with RLD RAM?
05-27-2020 08:02 AM
The snapshot of the IBIS model RLDRAM3 is attached for reference.
As provided in the comment section of the DQ model shown above, it says 1.2V HSTL I/O logic. (Same is shown for DQS with DIFF HSTL), but no I/O logics are mentioned for the Command signals or the Clock signals.
Now what is the logic I/O need to be considered at the FPGA end?
05-27-2020 10:27 AM
This is from the RLDRAM3 device IBIS model.
The FPGA RLDRAM3 IP uses SSTL12.
For your simulation, the FPGA will use SSTL12. The RLDRAM3 will use HSTL.
05-30-2020 12:18 PM
My design has Kintex ultra-scale plus FPGA "flvf1924" interfaced with two "IS49RL36320" RLD3 RAM.
The address lines follow flyby topolgy and the same is even cross checked with "UG583 design guideline".
The address lines are not meeting the thresholds. I initially doubted RLD3 RAM model, i tried models from different vendor like Micron and the same behavior is observed.
When i checked with Zynq ibis model the address lines are meeting the noise margins very vell for the same topology (ISSI part as well as Micron part).
Is there any issue with Kintex ibis model.
Address is operating at 533 MHz.
Here are the snapshot for your reference
1) Eye probed at RLD3 Address input (@die) with Kintex "HP_SSTL12_M_OUT40" model as driver
2) Eye probed at RLD3 Address input (@die) with zynq "HP_SSTL12_M_OUT40" model as driver
Please share your comments, your support is greatly appreciated.