cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
gd8021
Observer
Observer
325 Views
Registered: ‎09-20-2010

RF analyzer

I'm trying to valuate the MTS on a customer ZU48DR board with RF analyzer. 

However it seems could not enable the MTS from the RF analyzer GUI, see below.

gd8021_1-1623088059057.png

Any suggestions? ASAP. 

 

0 Kudos
4 Replies
pthakare
Moderator
Moderator
282 Views
Registered: ‎08-08-2017

Hi @gd8021 

Is the MTS option enabled while configuring the IP?

-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution
-------------------------------------------------------------------------------------------------------------------------------
0 Kudos
gd8021
Observer
Observer
247 Views
Registered: ‎09-20-2010

Hi Pthakare,

I running the files from the RF Analyzer installation directory. 

 

0 Kudos
pthakare
Moderator
Moderator
214 Views
Registered: ‎08-08-2017

Hi @gd8021 

Is the board you are using is custom board with  ZU48DR device or ZCU208 evaluation board ?

Are the clocks programmed properly before opening the RF analyzer ? I mean MTS required PL sysref and analog sysref , is the LMK programmed accordingly to provide the required frequency PL SYSREF and ANALOG SYSREF

 

-------------------------------------------------------------------------------------------------------------------------------
Reply if you have any queries, give kudos and accept as solution
-------------------------------------------------------------------------------------------------------------------------------
0 Kudos
gd8021
Observer
Observer
182 Views
Registered: ‎09-20-2010

#1

It's a customer board. The clock, SYSREF for both PL and DAC are set. 

#2

CLK_DAC0 is used for all AXI4 streaming interfaces. 

 

0 Kudos