cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
saad10
Observer
Observer
2,817 Views
Registered: ‎12-12-2012

MIMO signal processing

Jump to solution

Dear All,

 

I am trying to build a decision feedback equalizer for the MIMO application in FPGA.  I have idea of both SDK and system generator as separte tools. I have a running matlab code, but not the simulink model. Can anyone give me directives on how to model this matlab code on FPGA.

 

Thanks, 

0 Kudos
1 Solution

Accepted Solutions
sofiene
Contributor
Contributor
2,955 Views
Registered: ‎06-03-2011

 

Hello,

 

Two solutions are possible:

 

1/  AccelDSP tool for Matlab code direct use, but this tool has been discontinued at 11.4 ISE version,

2/ Try to modulate your Matlab code under Simulink to use SysGen, and in Simulink there is the Xilinx "M-block" which allow you to integrate an M-code in you Simulink/SysGen design,

 

Regards

View solution in original post

0 Kudos
1 Reply
sofiene
Contributor
Contributor
2,956 Views
Registered: ‎06-03-2011

 

Hello,

 

Two solutions are possible:

 

1/  AccelDSP tool for Matlab code direct use, but this tool has been discontinued at 11.4 ISE version,

2/ Try to modulate your Matlab code under Simulink to use SysGen, and in Simulink there is the Xilinx "M-block" which allow you to integrate an M-code in you Simulink/SysGen design,

 

Regards

View solution in original post

0 Kudos