UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
548 Views
Registered: ‎12-05-2018

Error Running CSI-Rx Application Example Design

Jump to solution

Hi,

I'm a fresh user trying to get acquainted with FPGA/ZYNQ programming.

In fact, I'm trying to run the application example design as described here (PG232).

So far I've purchased the required hardware and am able to run the tutorial up to point step 12. on page 68.

I'm unable to Open IP Example Design as this option is greyed out, even after generating the outputs as described earlier.

Did anyone experience this before?

How can I continue?

Is this a license issue? I have access to the default licenses available with ZCU102 EvalBoard. I'm not sure if this is included or not.

Thank you in advance.

Best Regards,

Kristof

 

0 Kudos
1 Solution

Accepted Solutions
523 Views
Registered: ‎12-05-2018

Re: Error Running CSI-Rx Application Example Design

Jump to solution

Solution : You need to wait until it becomes available ... :)

As part of generating the outputs, you simply need to wait until submodule runs are completed,

progress can be followed in "Design Runs" tab. (little turning symbol)

 

3 Replies
542 Views
Registered: ‎12-05-2018

Re: Error Running CSI-Rx Application Example Design

Jump to solution

Update: Via IP catalog I checked for license status on MIPI CSI-s Rx Subsystem and it confirms "Status:Bought", so license should not be an issue.

524 Views
Registered: ‎12-05-2018

Re: Error Running CSI-Rx Application Example Design

Jump to solution

Solution : You need to wait until it becomes available ... :)

As part of generating the outputs, you simply need to wait until submodule runs are completed,

progress can be followed in "Design Runs" tab. (little turning symbol)

 

Moderator
Moderator
462 Views
Registered: ‎11-09-2015

Re: Error Running CSI-Rx Application Example Design

Jump to solution

Hi kli@melexis.com,

Patience is the key to everything ;)

Thank you for sharing the solution. Could you kindly mark your last reply as accepted solution to close the topic?

Thanks and Regards,


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**
0 Kudos