UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Newbie afsanchez13
Newbie
3,909 Views
Registered: ‎04-07-2016

Matlab closes automatically in hardware co-simulation

I am using Hardware co-simulation of System Generator with Matlab 2013a, When I click on New Compilation Target then detect, Matlab closes automatically.

 

Thank you very much.

0 Kudos
2 Replies
Xilinx Employee
Xilinx Employee
3,904 Views
Registered: ‎02-06-2013

Re: Matlab closes automatically in hardware co-simulation

Hi

 

Which version of ISE or Vivado are you using.

 

Check if they are compatible from below links

 

http://www.xilinx.com/support/answers/17966.html

http://www.xilinx.com/support/answers/55830.html

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------
0 Kudos
Newbie afsanchez13
Newbie
3,872 Views
Registered: ‎04-07-2016

Re: Matlab closes automatically in hardware co-simulation

Hi

 

I am using ISE 14.7 which it is compatible with Matlab 2013a according to information from Xilinx.
The strange thing is that it worked before, it had uninstalled and now presents this error.

 

I am going to install ISE 14.6 and to test.

 

Regards.

0 Kudos