05-21-2014 07:55 PM
Thanks for the information above. I am hoping that this site will give help and may it also give development to all users.
06-08-2014 11:47 AM
Sir i m using xpower analyser in xilinx 13.2 version.In my project i need to find out 4 digit number after dot point but the xpower analyser only shows 3 digits after dot. so can u please help me how to find the four digits after dot.....
06-08-2014 02:04 PM - edited 06-08-2014 02:07 PM
Please start a new thread in this forum. Use viewing all the threads in this forum, use the 'New Message" button to start a new thread.
I am guessing that there is not enough certainty in the estimated and calculated numbers to warrant figures down to .0001 Watts of resolution.
-- Bob Elkind
09-02-2015 03:14 AM
Hi, I'm new and can't seem to post any new topics. They breifly get created, then vanish as soon as I refresh. Can someone please help?
It even says in my profile that I've posted X number of times.
01-24-2016 09:28 AM
Thank you very much for the introduction. And especially to the tutorials since I'm very new here :)
Keep it up! :)
04-09-2016 08:27 PM
Hello every one, I am a student from india learning basics in Xilinx ISE to Program Spartan 6 XC6SL9 FPGA. I also have a Xilinx Platform Cable USB Type 1. I am experiencing problem with the cable. When i connect the cable to my laptop, It displays "USB device not recognized" & when i view it in Device Manager, It displays something like "Device Descriptor Request Failed".
please help me...
and also please forgive me for poor formatting of the text and english.
04-20-2016 12:48 AM
I’m trying to generate configuration file for silent/unattended install for vivado 2014.4, I also need command line to execute the (batch file) install please?
04-24-2016 06:55 AM
Ignore this... was having trouble posting on another thread here on Xilinx.com and needed a thread to chuck a test message on
08-25-2016 08:20 AM
Hello. I currently use C code on a BeagleBoard to load a Xilinx FPGA and then interface to this FPGA to control external circuitry. I am hoping I can move the design to the Z-turn board.My goal is to ONLY use the processor/Ethernet/FPGA. I will not be using the other peripherals.
The FPGA bit file will be provided to me. Can C code load various bit files into its internal FPGA? How can my C code interface (shared memory?) with the FPGA?
But to do this I need help/direction/documentation to program a Zynq-based Z-turn board.
Thanks for any help/direction.
10-04-2016 09:33 AM
Thank you. Very insightful guidelines/tips for newbies. One basic question (I have not used forums in the past): How do I post a new thread or question?