UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Observer arash-rezaee
Observer
4,100 Views
Registered: ‎06-12-2012

Configuration ML605 with Impact problem

Jump to solution

Hi every one. I am using ISE 13.4 and Windows 7 (32 bit). I bought ML605 board and now I want to configure FPGA with iMPACT and Chipscop. When I open iMPACT software I choose "Configure device using boundary scan" and it started to scan for JTAG. When the searching finished, the warning appeared. The warning is : "WARNING :iMPACT:923 - cannot find the cable, check cable setup" . I Looked at device manager to see if the usb cable installed correctly or not. And it is fine. In device manager I have :"programming cable => Xilinx USB Cable ".

 

What should I do to correct this warning?

 

Regards

Arash

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Observer arash-rezaee
Observer
5,071 Views
Registered: ‎06-12-2012

Re: Configuration ML605 with Impact problem

Jump to solution

Hi every one.

 

For those has this problem I found the solution.

refere to this link and follow the structure, then you can use USB JTAG

 

http://www.xilinx.com/support/answers/41442.htm

 

Regards

Arash

View solution in original post

0 Kudos
3 Replies
Observer arash-rezaee
Observer
4,099 Views
Registered: ‎06-12-2012

Re: Configuration ML605 with Impact problem

Jump to solution
I am using ISE 13.3 Not 13.4. Sorry for mistake
0 Kudos
Highlighted
Observer arash-rezaee
Observer
5,072 Views
Registered: ‎06-12-2012

Re: Configuration ML605 with Impact problem

Jump to solution

Hi every one.

 

For those has this problem I found the solution.

refere to this link and follow the structure, then you can use USB JTAG

 

http://www.xilinx.com/support/answers/41442.htm

 

Regards

Arash

View solution in original post

0 Kudos
Newbie eshwaran
Newbie
4,052 Views
Registered: ‎08-21-2012

Re: Configuration ML605 with Impact problem

Jump to solution
Thanks!!! It worked for me
0 Kudos