cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
241 Views
Registered: ‎02-27-2020

FMC Vadj on ZCU106

Jump to solution

Hi

I have a question of FMC Vadj of ZCU106.

Seeing in schematics, MAX15301 generates Vadj=1.8V in default.

When the other Vadj value is required, how does the system controller change Vadj?
Does it just issue VOUT_COMMAND for MAX15301?

 

BestRegards
u-sui

 

 

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
224 Views
Registered: ‎06-06-2018

Hi @u-sui ,

Yes, VOUT_Command will get issued. This will be done with the help of MSP430 on Board.

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post

2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
225 Views
Registered: ‎06-06-2018

Hi @u-sui ,

Yes, VOUT_Command will get issued. This will be done with the help of MSP430 on Board.

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post

Highlighted
Observer
Observer
218 Views
Registered: ‎02-27-2020
Hi D N
Thank you for your reply.
I understood.
BestRegards
u-sui
0 Kudos