cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Participant
Participant
215 Views
Registered: ‎01-12-2020

How to check jumper setting (TDO-TDI)?

Jump to solution

Hi,

I try to use XM105 for debugging  the signal from KCU105 evaluation borad.

I connected XM105 to KCU105. Aftert XM105 connection, I cannot open device from vivado. However, disconnecting XM105, I can open device.

I try to check jumper settings at XM105 board. but I don't know check jumper setting.

How to check jumper setting?

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Voyager
Voyager
183 Views
Registered: ‎03-28-2016

Re: How to check jumper setting (TDO-TDI)?

Jump to solution

@ysjung 

On the XM105 board, look for a set of pins with the label "J5".  Make an electrical connection between pins 6 and 7.

https://www.xilinx.com/support/answers/52888.html

https://www.xilinx.com/support/documentation/boards_and_kits/ug537.pdf

Ted Booth - Tech. Lead FPGA Design Engineer
https://www.designlinxhs.com

View solution in original post

Tags (1)
1 Reply
Highlighted
Voyager
Voyager
184 Views
Registered: ‎03-28-2016

Re: How to check jumper setting (TDO-TDI)?

Jump to solution

@ysjung 

On the XM105 board, look for a set of pins with the label "J5".  Make an electrical connection between pins 6 and 7.

https://www.xilinx.com/support/answers/52888.html

https://www.xilinx.com/support/documentation/boards_and_kits/ug537.pdf

Ted Booth - Tech. Lead FPGA Design Engineer
https://www.designlinxhs.com

View solution in original post

Tags (1)