UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
785 Views
Registered: ‎09-07-2016

Power Advantage Demo v1.00 on ZCU102 Rev 1.0(silicon version 3/4)

Jump to solution

Hi experts,

 

I'm not sure what's the status for the following information:

 

# minicom -D /dev/ttyUSB3

!! Power Advantage Demo v1.00

!! Press ESC to enter System Controller mode.

 

Not like before there is a menu for PM-related, I can operate as the menu prompt.

"Press ESC" does  not work either, which means, no response any more.

 

There are two different status on /dev/ttyUSB0(Which suppose the output console for FSBL and u-boot)

On Silicon v3:

      There is no any output from /dev/ttyUSB0, which means it might be stuck in CSU bootrom.

 

      Question: Is there any way to get the board out of this stuck?

 

On Silicon v4:

      Normal output from /dev/ttyUSB0

   

      Question: Do I need to care the output from /dev/ttyUSB3?

 

Cheers, (Happy new coming year)

Zumeng

0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator
1,113 Views
Registered: ‎11-09-2015

Re: Power Advantage Demo v1.00 on ZCU102 Rev 1.0(silicon version 3/4)

Jump to solution

Hi zumeng.chen@windriver.com,

 

To use the power tool on ZCU102 rev1+ you need to use the ZCU102 SCUI tool. See AR#67308 for more information

 

Remember to close the UART terminal on this port to let the access to the tool.

 

Hope that helps,

 

Regards,

 

Florent


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos
2 Replies
Moderator
Moderator
1,114 Views
Registered: ‎11-09-2015

Re: Power Advantage Demo v1.00 on ZCU102 Rev 1.0(silicon version 3/4)

Jump to solution

Hi zumeng.chen@windriver.com,

 

To use the power tool on ZCU102 rev1+ you need to use the ZCU102 SCUI tool. See AR#67308 for more information

 

Remember to close the UART terminal on this port to let the access to the tool.

 

Hope that helps,

 

Regards,

 

Florent


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos
685 Views
Registered: ‎09-07-2016

Re: Power Advantage Demo v1.00 on ZCU102 Rev 1.0(silicon version 3/4)

Jump to solution

Thanks ~, I'll take a look, anyway, feel free to close this case.

0 Kudos