cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Newbie
Newbie
5,108 Views
Registered: ‎11-08-2007

Sending a Frame using Tri-mode ethernet MAC

I tried to send a packet from ML405 via Tri-mode ethernet MAC (Temac) configured scatter-gather.
The examples supplied with EDK implement scatter-gather using interrupts.
How can I poll the status of the DMA to know it is done (without interrupts) ?
When I sent a frame I saw nothing on an ethernet sniffer.
Should I change some DIP switches from factory setting ?
I tried to send packets with Emac on this board and it worked fine.
I connected the Ethernet cable to the RJ45 socket. The RX, DUP LEDs are on all the time.
Thanks.
0 Kudos
0 Replies