cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
380 Views
Registered: ‎10-02-2018

VCU118 Mounting Hole Dimensions

Jump to solution

Hi,

I want to design a case for VCU118 and am looking for dimensions of the mouting holes. From XTP451 I was able to get dimensions for the lower and the middle ones on the left,  and two on the right side, but no dimensions for the top left one and two in the middle. Are there any other file I can look into?

Thanks,

Kazu

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
338 Views
Registered: ‎08-01-2019

Hi @sakai_at_nasa,

At the bottom of this webpage (https://www.xilinx.com/products/boards-and-kits/vcu118.html#documentation) you can find two zip files to download which will give you the Allegro and Gerber files.

However, we don't recommend putting evaluation boards in cases due to these boards not being designed or tested for production environments. 

https://www.xilinx.com/support/answers/43302.html

Sincerely,

Courtney

 

----------------------------------------------------------------------------------------------------------------------
Please don’t forget to reply, give kudos, and accept as a solution if you found this helpful!
----------------------------------------------------------------------------------------------------------------------

View solution in original post

2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
339 Views
Registered: ‎08-01-2019

Hi @sakai_at_nasa,

At the bottom of this webpage (https://www.xilinx.com/products/boards-and-kits/vcu118.html#documentation) you can find two zip files to download which will give you the Allegro and Gerber files.

However, we don't recommend putting evaluation boards in cases due to these boards not being designed or tested for production environments. 

https://www.xilinx.com/support/answers/43302.html

Sincerely,

Courtney

 

----------------------------------------------------------------------------------------------------------------------
Please don’t forget to reply, give kudos, and accept as a solution if you found this helpful!
----------------------------------------------------------------------------------------------------------------------

View solution in original post

Highlighted
Observer
Observer
303 Views
Registered: ‎10-02-2018

Hi celliott,

Thanks! I didn't know we can even download gerber files. The case is still for a prototype, not for production. It's nice to have a case even for a prototype.

-K

0 Kudos